OBD-II Trouble Code Technical Description
Article by
Randy Worner
ASE Certified Master Technician
Transmission Fluid Pressure Sensor / Switch "B" Circuit Range Performance Rationality
What does that mean?
This generic powertrain/engine diagnostic trouble code typically applies to all OBD-II equipped vehicles including but not limited to Jeep, Dodge, Mazda, Nissan, Honda, GM, etc.
The Transmission Fluid Pressure Sensor/Switch (TFPS) is usually found attached to the side of the valve body inside the transmission, although sometimes it may be found screwed into the side of the transmission case/body itself.
The TFPS converts the mechanical transmission pressures into an electrical signal for the Powertrain Control Module (PCM) or Transmission Control Module (TCM). Typically, the PCM/TCM will then inform other controllers utilizing the vehicle's data communication bus.
The PCM/TCM receives this voltage signal to determine transmission operating pressure or when a shift is occurring. This code is set if this "B" input does not match normal operating voltages stored in the PCM/TCM's memory. It may also be due to internal mechanical issues inside the transmission. Refer to a vehicle specific repair manual to determine which is the "B" circuit for your particular vehicle.
P0846 is typically an electrical circuit (TFPS sensor circuit) issue, although as previously stated this code may also be set due to mechanical issues (internal leaks, cracked or missing check balls in the valve body, low system operating pressure/main line pressure, stuck valve in the valve body). This cannot be overlooked in the troubleshooting stage, especially when dealing with an intermittent problem.
Troubleshooting steps may vary depending upon manufacturer, type of TFPS sensor and wire colors.
Related trans fluid pressure sensor B circuit codes:
- P0845 Transmission Fluid Pressure Sensor/Switch "B" Circuit
- P0847 Transmission Fluid Pressure Sensor/Switch "B" Circuit Low
- P0848 Transmission Fluid Pressure Sensor/Switch "B" Circuit High
- P0849 Transmission Fluid Pressure Sensor/Switch "B" Circuit Intermittent
Code Severity & Symptoms
Severity depends upon which circuit the failure has occurred in. Since this is an electrical failure, the PCM/TCM can compensate to some degree. The failure may mean that the PCM/TCM modifies the shifting of the transmission if electronically controlled.
Symptoms of a P0846 engine code may include:
- Malfunction Indicator Light On
- Change in shift quality
- Vehicle starts off in 2nd or 3rd gear (limp in mode)
Causes
Typically the causes for this code to set are:
- Open in the signal circuit to the TFPS sensor - possible
- Short to voltage in the signal circuit to the TFPS sensor - possible
- Short to ground in the signal circuit to the TFPS sensor - possible
- Failed TFPS Sensor – likely
- Internal mechanical transmission issue - possible
- Failed PCM - unlikely (programming required after replacement)
Diagnostic and Repair Procedures
A good starting point is always to check for technical service bulletins (TSB) for your particular vehicle. Your issue may be a known issue with a known fix put out by the manufacturer and can save you time and money during diagnosis.
A good example of this would be if there are any known power related codes set along with the P0846, or if there is more than one pressure sensor/switch code set. If so, begin your diagnosis with the power related fault code first, or with the multiple code diagnosis first, as this may be the reason for the P0846.
Next, locate the Transmission Fluid Pressure Sensor/Switch (TFPS) on your particular vehicle. The TFPS is usually found attached to the side of the valve body inside the transmission, although sometimes it may be found screwed into the side of the transmission case/body itself. Once located, visually inspect the connector and wiring. Look for scraping, rubbing, bare wires, burn spots or melted plastic. Pull the connector apart and carefully inspect the terminals (the metal parts) inside the connector. See if they look burned or have a green tint indicating corrosion, especially if they are attached outside the transmission case. Use electrical contact cleaner and a plastic bristle brush if cleaning of the terminals is needed. Let dry and apply electrical grease where the terminals contact.
If you have a scan tool, clear the diagnostic trouble codes from memory, and see if P0846 code returns. If it does not, then the connections were most likely your problem.
This is the most common area of concern for this code, as the external transmission connections have the greatest number of issues with corrosion.
If the P0846 code does return, we will need to test the TFPS sensor and its associated circuits. With the Key Off, disconnect the electrical connector at the TFPS sensor. Connect a Digital Voltmeter (DVOM) black lead to the ground or low reference terminal at the TFPS sensor wiring harness connector. Connect the red lead of the Digital Voltmeter to the signal terminal at the TFPS sensor wiring harness connector. Turn Key On Engine Off. Check manufacturer's specifications; voltmeter should read either 12 volts or 5 volts. Wiggle the connections to see if they change. If the voltage is incorrect, repair the power or ground wire, or replace the PCM/TCM.
If the prior test passed, connect one lead of an ohmmeter to the signal terminal at the TFPS sensor and the other lead to the ground or low reference terminal at the sensor. Check manufacturers specifications on the resistance of the sensor to accurately test the resistance to pressure when there is no pressure applied to it. Wiggle the connector at the Transmission Fluid Pressure Sensor/Switch while monitoring the resistance. If the ohmmeter readings do not pass, replace the TFPS.
If all prior tests have passed and you continue to get a P0846, this would most likely indicate a failed TFPS sensor, although a failed PCM/TCM could not be ruled out, nor could internal transmission malfunctions until the TFPS sensor had been replaced. If unsure, seek assistance from a trained automotive diagnostician. PCM/TCMs must be programmed, or calibrated to the vehicle in order to be installed correctly.
Related DTC Discussions
- 2005 Town and Country p0846 p0888 p0891 p0700
I'm having trouble with my Town & Country I'm reading codes p0846 p0888 and p0891 as well as O2 sensor code I have already change the O2 sensor and it has came back up after I reset the codes the first three codes are new and that also is in conjunction with a P0700 that I have also seen I'm won...
- Nissan Sentra codes P0102 P0113 P0846 P0965 and P0712
My Nissan Sentra 2016 code read P0102 code i replaces it! Check Engine light still on still riding bad.....Now i have more codes as follows....P0113...P0846.....P0965......P0712.......Pleas help...
- 2004 neon HELP!!! p0562 p0841 p0992 p0846 p0732
p0731
I have a 2004 neon with 87 k miles on it and i have driven it and then it just stops working. I did a obd scan and got the following codes, i need to know if you have any suggestions as to what needs repaired. all are PO codes 562,841,992,846,732,731,and 700. this is frustrating me because i dont kn...
- Check Engine light: Code P0846 2012 Nissan Versa
Can somebody explain what this code means and also how should I systematically troubleshoot?...
- 2005 Jeep wrangler X 4WD error codes P0700 and P0846 Problem
In the past few months, My check engine light has popped on here and there. The same problem code has popped up each time. I would like to have more information on P0700 code and why it is in combination to the P0846 code. If you are able to help me with this or have had the same problem and have fo...
- 2014 nissan sentra p0846 help!!!!!
hi everybody and i will aprexiate your help my 2014 nissan sentra wont accelerate in park or neutral in drive it take a long time to gain speed i think its stuck in 3rd gear and it has little power in reverse too, the problem started because it lost trans fluid but we fixed the oil pan and put like ...
- 2012 Nissan Juke P0846 P0720
Mohon Bantuannya .menganalisis atau Mencari Tau Tengtang Kode P0846 Dan P0720 . Apakah Kode ini.Menunjukan Harus Ganti VSS dan TCM nya ,atau bisa yang lain lain. ( Problem yang saya alami ini di Kendaran Nisan Juke dengan Tranmisi Metic Tahun 2012 .dan Isi Slinder 1500cc. Bila Di Kendarai Di atas 3...
Need more help with a p0846 code?
If you still need help regarding the P0846 trouble code, please post your question in our FREE car repair forums.
NOTE: This information is presented for information purposes only. It is not intended as repair advice and we are not responsible for any actions you take on any vehicle. All information on this site is copyright protected.