Show EZwipers is the easiest and quickest way to find replacement windshield wiper blades for your car or truck. All wipers are 100% guaranteed to fit and are available for most cars, including Ford, Chevrolet, Toyota, Nissan, Honda, Dodge, Hyundai, Volkswagen, Mazda, and Subaru. EZwipers only carries top-rated, brand quality wipers, including the Anco
31 series wipers, Anco Contour wipers, Anco Winter wipers, Anco Rear AR wipers, and Rain-X Latitude wipers. ©2016 Honda Pilot Rear Window Wiper Blade Replacement Guide
Owner's of other Honda or Acura SUV, minivan or hatchback vehicles such as the Odyssey, Insight, CR-V, Fit, CR-Z, Crosstour, MDX and RDX may also find these DIY instructions to be helpful. The rear wiper blade on this 2nd generation pilot is 14" (inches) or 356mm in length. The OEM replacement rear wiper blade assembly from Honda is part # 76730-SZA-A02 (also known as "76730SZAA02"). No tools are needed to change the wiper blade. Pull Wiper Arm Away Rotate Old Wiper Blade Pop Bar Out of Socket The first step is to gently pull the black plastic cover off the base of the wiper arm. Set the cap aside in a safe place. Then pull the wiper arm up and away from the rear window until it is almost perpendicular to the vehicle and remains in that position by itself. Rotate the old wiper blade away from the arm at an angle. Continue rotating the blade away from the arm until the mounting bar in the center of the old wiper blade can be popped out of the "C" socket at the end of the wiper arm. Mounting Bar & "C" Socket "C" Socket On Wiper Arm Mounting Bar - Center of Blade You may either replace the entire wiper assembly or your Honda dealer may have the cheaper rubber wiper refills. I found it more time effective to just replace the entire wiper assembly rather than pull out the old rubber inserts and thread in the new ones. The part number is Genuine Honda 76730-SZA-A02. The OEM Honda wiper blade assembly can be purchased on eBay, Amazon or various other Honda parts websites. Line Up Bar & Socket Insert Bar In To Socket Pop In Mounting Bar Line up the plastic bar in the center of the new wiper blade with the "C" shaped socket at the end of the wiper arm. Pass the end of the wiper arm through the opening in the new wiper blade. Pop the mounting bar in to the "C" shaped socket. Rotate Blade Parallel New Blade Installed Wiper Tab & Resting Slot Rotate the new wiper blade until it is parallel with the wiper arm. Move the wiper arm towards the rear window. Re-Insert Tab In Slot Line Up End Cap Snap Cover In Place Re-insert the plastic tab on the wiper blade in to the slot on the mounting bracket attached to the tailgate where the wiper arm rests when it is not in use. Line up the black plastic cover and gently snap it in to place over the base of the wiper arm. (If the wiper arm base cap has been broken or lost, the replacement Honda OEM part # is 76730-SZA-A02.) For more, please check out my other 2009-2015 Honda Pilot DIY Repair & Maintenance Guides. What size windshield wipers does a 2010 Honda Pilot take?22" wiper blade.
What size wiper blades does a Honda Pilot take?Specifications. How do you change the rear wiper blade on a 2008 Honda Pilot?Release the old blade. Lift the wiper arm off the window. ... . Remove the wiper. The blade will release from the wiper arm. ... . Position the new blade. Place the small bar attachment on the new wiper blade into the hook on the wiper arm.. Lock the blade into place. Rotate the blade away from you and it will snap into place.. |